When applying Foil tape, to ensure its best fixing effect and service life, you need to pay attention to the following points:
Clean the surface:
Before applying Foil tape, first make sure that the surface to be applied is clean, tidy, and free of dust, oil and other pollutants. These pollutants will affect the stickiness of the tape and reduce its fixing effect. Therefore, clean the surface with tools such as dry cloth or dry brush before use.
Accurate measurement:
Accurately measure the required length of Foil tape according to the length of the surface to be applied. This can avoid waste and ensure that the tape fits tightly to the surface. Prepare tools such as scissors and cutting knives for precise cutting when needed.
Peeling off the protective layer:
Before using Foil tape, you need to peel off the protective layer at the bottom. During the peeling process, try to avoid stretching or twisting the tape to avoid affecting its performance and shape.
Alignment and fitting:
Place the Foil tape on the surface to be applied, starting from one side and gradually aligning it to the other side. Make sure the position of the tape is the same as the position of the surface to avoid misalignment or gaps. During the lamination process, the protective layer should be torn off while the tape is lightly pressed with the fingertips to make it fit tightly to the surface.
Compacting and checking:
After lamination, use your fingers or tools such as pressure rollers to compact the Foil tape to ensure that it is close to the surface. Then, check whether there are gaps or bubbles between the tape and the surface, and adjust and correct them where necessary.
Precautions:
When pasting Foil tape, avoid excessive stretching to prevent the tape from being pulled off or not fitting tightly. At the same time, ensure that the pasting surface is dry to prevent the tape from being damp and affecting its stickiness. In addition, Foil tape is not suitable for sticking to horizontal surfaces to avoid causing the pasted part to slip.
Storage and protection:
Foil tape should be stored in a dry, cool, ventilated environment, away from direct sunlight and high temperature. At the same time, during the pasting process, avoid contact with sharp objects to avoid scratching the surface of the tape.
In short, the above points need to be paid attention to when pasting Foil tape to ensure its best fixing effect and service life.
